2-73
BEFORE DRIVING
80SS5-01E
NOTE:
Depending on vehicle’s specifications,
some items may not be displayed.
How to use the setting mode:
1) When the ignition switch is in “ON”
position or the ignition mode is ON, and
the vehicle is stationary.
2) Push and hold the indicator selector
knob (2) until the display shows
“”.
3) Turn and/or push the indicator selector
knob (2) to select a function that you
want to set up according to the chart in
the previous page.
4) Turn and/or push the indicator selector
knob (2) to register settings of the fol-
lowing functions.
68PM00272
NOTE:
• As shown in the above illustration, “ ”
indicates on the display of currently set-
ting item.
• To go back to the higher level display
during operation, turn the indicator
selector knob (2) to display “ ” or
“ ” and then push the indicator
selector knob (2).
Time indication of clock “ ”
• : 12-hour format (default set-
ting)
• : 24-hour format
Central door locking system “ ”
• : Unlock all doors by turning
the key once
• : Unlock all doors by turning
the key twice (default setting)
Door locking and unlocking
buzzer “ ”(if equipped)
• : Buzzer sounds when the
doors (including the tailgate)
are locked or unlocked by
using the keyless push start
system remote controller or
request switch (default set-
ting)
: Buzzer does not sound when
the doors (including the tail-
gate) are locked or unlocked
by using the keyless push
start system remote controller
or request switch
Additional flashes of the turn signal
“”
• : Turn signal flashes three
times after the turn signal
lever is returned (default set-
ting)
• : Disable the additional flashes
of turn signal
Security system “ ”(if equipped)
• : Enable the security system
(default setting)
• : Disable the security system
Tyre pressure monitoring system set-
ting (if equipped)
• : Comfort Mode (default set-
ting)
• : Load Mode
Refer to “Tyre pressure monitoring system
(TPMS)” in “OPERATING YOUR VEHI-
CLE” section for details.
Initialization setting “ ”
• : Initialize all settings
How to exit the setting mode:
Switch the display to show “ ” and then
push the indicator selector knob (2).
Turn the indicator selector knob
(2).
Push the indicator selector
knob (2).