3-36
ADD THE ENGINE OIL
Follow the following procedure to add
additional engine oil.
1. Idle the engine for three minutes in a
flat area, and then stop the engine.
2. Wait three minutes, then remove the
oil filler cap
3.
3. Hold the motorcycle upright, and
add oil so that the surface of the
engine oil is between F (upper level)
1 and L (lower level) 2.
4. Attach the cap
3 firmly.
NOTICE
Operating the motorcycle with too lit-
tle or too much oil can damage the
engine.
Place the motorcycle on level
ground. Check the oil level in the
engine oil inspection window before
each use of the vehicle. Be sure the
engine oil level is always above the
“L” (low) line and not higher than the
“F” (full) line.
To Next Page
Loading...
