3-42
10.Replace the drain plug gasket 5
with a new one. Reinstall the drain
plug
4 and gasket 5. Tighten the
plug securely with a torque wrench.
Pour 3.2/2.6 US/Imp. qt (3000 ml) of
new engine oil through the filler hole
and install the filler cap. Be sure to
always use the specified engine oil
described in the “SELECTING THE
ENGINE OIL” section on page 3-31.
Drain plug tightening torque:
16.5 lbf-ft (23 N·m, 2.3 kgf-m)
NOTE: About 2.9/2.4 US/Imp. qt (2700
ml) of oil will be required when chang-
ing oil only.
Mark top dead center
Oil filter wrench
Tighten the filter 2 turns or to specified
torque.
In the position at which
the filter gasket first
contacts the mounting
surface.
To Next Page
Loading...
