3-90
8. Remove the rear brake caliper
assembly
8.
9. Pull the rear wheel assembly
9 rear-
ward.
NOTE: Never depress the rear brake
pedal with the rear wheel removed. It is
very difficult to force the pads back into
the caliper assembly.
10.To replace the wheel, reverse the
complete sequence listed.
11.Adjust the drive chain slack.
12.After installing the wheel, apply the
brake several times and then check
that the wheel rotates freely.
Rear axle nut tightening torque:
72.5 lbf-ft (100 N·m, 10.0 kgf-m)
Chain adjuster lock nut tightening
torque:
16.0 lbf-ft (22 N·m, 2.2 kgf-m)
Rear wheel speed sensor mounting bolt
tightening torque:
7.0 lbf-ft (10 N·m, 1.0 kgf-m)
To Next Page
Loading...
