3-93
Front and rear turn signal light
(V-STROM 1050)
To replace the front and rear turn signal
light bulb, follow these directions.
1. Remove the screw and take off the
lens
1.
2. Push in on the bulb
2, twisting it to
the left, and pull it out.
3. To fit the replacement bulb, push it in
and twist it to the right while pushing.
4. Reinstall the lens.
NOTICE
Overtightening the screws when
reinstalling the lens may cause the
lens to crack.
Tighten the screws only until they
are snug.
To Next Page
Loading...
