2-59
Setting
The ABS mode can be changed in the fol-
lowing conditions A or B:
A: When the motorcycle is stopped
B: When the throttle is fully closed and
brakes are not operated while riding the
motorcycle
Make the settings according to the proce-
dure below.
If you turn off the ignition switch while mak-
ing settings, the settings (Mode-1 or Mode-
2) at the time of turning the ignition switch
off are selected. If the mode is set to Rear-
OFF, the settings are canceled each time
the ignition switch is turned off, and Mode-1
is set.
1. Display the RIDE view.
2. Press the MODE switch 1 to select
ABS. When you select ABS, it is high-
lighted.
WARNING
Concentrating on the meters and
switches while riding is dangerous.
If you must change the ABS mode while
riding, be sure to pay sufficient attention
to the safety of the surroundings.
To Next Page
Loading...
