Suzuki VZR1800 2008 User Manual

9-74 CHASSIS
VALVE INSPECTION
• Inspect the valve after the tire is removed from the rim.
• Replace the valve with a new one if the seal A rubber is peel-
ing or has damage.
NOTE:
If the external appearance of the valve shows no abnormal con-
dition, removing of the valve is not necessary.
If the seal has abnormal deformation, replace the valve with a
new one.
• Any dust or rust around the valve hole B must be cleaned off.
• Then install the valve C in the rim.
NOTE:
To properly install the valve into the valve hole, apply a special
tire lubricant or neutral soapy liquid to the valve.
$
Be careful not to damage the lip C of valve.

Suzuki VZR1800 2008 Specifications

General

Displacement	1783 cc
Bore x Stroke	112.0 mm x 90.5 mm
Compression Ratio	10.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Engine Type	4-stroke, liquid-cooled, DOHC, V-twin
Front Tire	130/70R18M/C 63H
Overall Length	2485mm (97.8 inches)
Overall Height	1185 mm
Ground Clearance	140 mm (5.5 in)
Seat Height	705 mm
Curb Weight	347 kg