2
4.3.1 After use, the boat and all components should be washed with a mild
soap and rinsed with fresh water. Dry all parts before storing in the
carrying bag. This will help prevent mould or mildew.
4.3.2 Wooden parts should be inspected for damage or deterioration.
Surface scratches or abrasions should be covered with a marine grade
varnish.
4.3.3 To keep the boat looking new, store the boat in a cool and dry place
and avoid excessive exposure to direct sunlight.
4.3.4 To avoid damaging the boat during storage, do not place heavy objects
on it.
5 Repair
5.1 Small tears, cuts and punctures
5.1.1 The repair of a small leak or puncture less than ½ inch (12.7 mm) can
be done with a round patch, 3 inches (76.2 mm) diameter, minimum.
5.1.2 Both patch and surface on the boat must be dry and free of dirt and
grease.
5.1.3 Apply 3 thin, even coats of adhesive to the surface of the boat and the
patch. Wait 5 minutes between each coat. After the 3rd coat, wait 10-
15 minutes before placing the patch on the boat skin.
5.1.4 Wait for at least 24 hours before re-inflating the boat.
5.2 Large repairs of fabric, seams and transom etc
For all large repairs it is recommended to return the boat to your dealer.
Contact him first, if possible.
6 Warranty policy
The two year guarantee only occurs on the condition that the warranty
registration card was returned 10 days following the data of purchase and
accompanied by a copy of the receipt/invoice.
6.1 We guarantee that each new inflatable boat and its accessories (hereinafter
to be referred to as the "product") is free from defects in material and
workmanship, but only when the sale has been made in a country to which
distribution is authorised by us.
6.2 This warranty applies only to defects in material and workmanship, it does not
apply to normal wear and tear, or to damage caused by:
1) Neglect, lack of maintenance, accident, abnormal or improper use or bad
assembly;
To Next Page
Loading...