Svan SJ12600E - User Manual

Questions and Answers

C
Cindy ParkerAug 15, 2025
What to do if my Svan SJ12600E Dishwasher programme does not start?
- K
  Krista SmithAug 15, 2025
  If the Svan Dishwasher programme isn't starting, there are several possible reasons. First, ensure the dishwasher is properly plugged in and switched on using the On/Off button. Check your indoor fuses and make sure the water inlet tap is open. Also, confirm that the dishwasher door is fully closed. Finally, inspect the water inlet hose and machine filters to ensure they are not clogged. If they are clogged, clean them.
M
Michelle PerryAug 18, 2025
Why does my Svan SJ12600E stop during washing?
- L
  lwoodAug 18, 2025
  If your Svan Dishwasher stops mid-cycle, it could be due to a power failure. Check your mains power supply. Alternatively, there might be a water inlet failure, so check the water tap to ensure it's open.
R
Richard JohnsonAug 21, 2025
What to do if water remains inside my Svan SJ12600E?
- B
  Brandi LeeAug 22, 2025
  If water remains in your Svan Dishwasher after a cycle, the drain hose might be clogged or twisted; inspect and clean or untwist it. The filters may also be clogged, so clean them. Alternatively, the program might not have finished yet, so wait until completion.
C
Carol HarrellAug 25, 2025
Why are there partial food wastes remaining on the dishes in my Svan SJ12600E?
- V
  Victor RodriguezAug 26, 2025
  If you notice food waste on dishes after a wash in your Svan Dishwasher, several factors could be at play. Ensure you're not overloading the baskets and that dishes aren't leaning against each other; refer to the loading instructions. Verify you're using enough detergent as per the programme table and have selected the correct wash programme. Check the spray arms for clogs and clean them with thin objects if necessary. Also, make sure the drain hose and filters are correctly fitted and not clogged.
G
gutierrezalexanderAug 28, 2025
Why does my Svan SJ12600E leave whitish stains on the dishes?
- L
  Lisa HarrisonAug 28, 2025
  If your Svan Dishwasher is leaving whitish stains on dishes, it could be due to insufficient detergent; use the correct amount as instructed in the programme table. The rinse aid dosage or water softener setting might be too low; increase them. Also, a high water hardness level can cause this, so increase the water softener level and add salt. Finally, ensure the salt compartment cap is properly closed.
J
Johnny SanchezAug 31, 2025
How to fix rust stains that form on the dishes in my Svan SJ12600E Dishwasher?
- A
  Andrew GriffithAug 31, 2025
  If rust stains appear on dishes washed in your Svan Dishwasher, it could be due to insufficient stainless-steel quality of your dishes; use only dishwasher-proof sets. A high salt level in the wash water can also cause this; adjust the water hardness level using the water hardness table. Ensure the salt compartment cap is properly closed and that you're using a funnel to avoid spillage when filling the salt compartment. If the issue persists, a poor mains grounding may be the cause; consult a qualified electrician immediately.
J
Joshua HallSep 4, 2025
Why are my dishes not drying in the Svan Dishwasher?
- K
  Katrina YoungSep 4, 2025
  If your dishes are not drying in the Svan Dishwasher, ensure that you have selected a program with a drying option. Also, the rinse aid dosage setting might be too low; increase it.
R
Robert BrewerSep 7, 2025
What causes shaking and hitting noises during a Svan SJ12600E Dishwasher wash operation?
- N
  Nicholas AlexanderSep 8, 2025
  Shaking and hitting noises during a wash in your Svan Dishwasher usually indicate that the spray arm is hitting dishes in the lower basket. To resolve this, move or remove the items that are blocking the spray arm.
J
jonesryanSep 10, 2025
Why does detergent remain in the detergent compartment of my Svan SJ12600E Dishwasher?
- J
  Joshua GonzalezSep 12, 2025
  If detergent remains in the compartment of your Svan Dishwasher, it might be because the detergent was added when the compartment was wet. Ensure the detergent compartment is dry before adding detergent.