EasyManua.ls Logo

Svan SJ12600E - Filling the Detergent; Using Combined Detergents; Rinse-Aid Usage; Filling the Rinse-Aid and Setting

Svan SJ12600E
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 15
amount of detergent needed depends on
the cycle, load size, and soil level of dishes.

compartment more than required; otherwise
you can see whitish streaks or bluish layers
on glass and dishes and may cause glass
corrosion. Continued use of too much
detergent may cause machine damage.
Using little detergent can result in poor
cleaning and you can see whitish streaksin
hard water.
See the detergent manufacturers
instructions for a further information.

Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in

before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.
DETERGENT

These products should be used according
to the manufacturers instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.

The rinse aid helps to dry the dishes
without streaks and stains. Rinse-aid is
required for stain-free utensils and clear
glasses. The rinse aid is automatically
released during the hot rinse phase. If
rinse aid dosage setting set too low, whitish
stains remains on dishes and dishes do not
dry and washed clean.
If rinse aid dosage setting set too height,
you can see bluish layers on glass and
dishes.


the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX
level and then close the cap. Be careful not

wipe up any spills.



󰀨

down.
Turn the knob counter clockwise one
step.


The machine will display the current
setting.

button.
󰀨
the setting.

If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.

Related product manuals