Svan SVI639 - Instructions For Use; Preparation Before Using; Operation Instructions; Boost Function

Instructions For Use
OR
Preparation Before Using:
After power on, the buzzer beep once, all the indicators light up for 1 second and
then go out, which indicates the induction hotplate enters the state of standby.
Put the pot in the center of the heating zone.
Operation Instructions:
When the “ON / OFF” button is pressed, all the indicators show "-" .
OR
According to the heating zone where the pot is placed, select a relevant zone
selection (e.g. select zone ), with a corresponding power level indicator
flashing.
At the moment, press the "+" or "-" button, the indicator displays 5, then adjust
the power levels using the "+" or "-" button.
AND
oost function
To get a quicker heating speed, there is a function named "Boost" will satisfy
your requirement.
Directly press the " Boost" button after selecting the heating zone, with the
power level indicator showing "P. " , and the heating power can reach up to
the max. .
B
Or press the "+" and "-" buttons simultaneously, the power setting immediately
change to 0, and all the cooking zone switch off.
See the attached table "the ma. power of each heating zone" for the power
specific to each heating zone.
Note 1. After the "ONO" button is pressed, the induction hotplate will
restore to its standby state if no any operation is carried out within one
minute.
24