Sven PS-150 - Connection and Operation; Operation Modes

ENG
4
Portable Speaker System
withBluetooth and FM-radio
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Speaker system battery charging
• Connect speaker system to a USB port of PC or USB charger using USB to USB type-C cable
(included). When charging, the indicator i will glow solid red. The indicator will turn o when
the battery is fully charged.
• The battery is used in the speaker system as an integral part ofthe device, therefore do not try
to extract or replace it, because this can result in the warranty cancellation or the device damage.
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect speaker system to compat-
ible devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls orother
electronic devices can interfere with the signal transfer.
• Turn on the speakers in Bluetooth mode.
• It is necessary to select the search mode of devices with Bluetooth on a signal source (tele-
phone, notebook, smartphone, etc.). "SVEN PS-150" / "SVEN PS-155" message will be displayed
on the screen which is to be connected to*.
• When connection is successful, there will be a short beep**.
Radio mode
• To improve radio reception, connect USB to USB type-C cable (included) to the input h.
Turn on the speaker system — press button b several times until, the radio mode will turn on.
Long-term pressing button d activates auto search mode. After scanning completion, therst
scanned radio station will start to operate automatically. With buttons c and e (long pressing)
select a desired radio station.
Рlayer mode
Attention! The le system of a USB ash carrier is FAT32. Maximum volume is 32 GB.
• Insert the USB ash carrier into appropriate slot. If the speaker system is in turned onposi-
tion, the playback will start automatically. Playback/Pause modes are switched over withthehelp
ofthe button d. Tracks can be controlled by buttons c (previous track) ande (next track).
Connecting an additional speaker
For model "SVEN PS-150, PS-155" you can connect an additional speaker (Bluetooth mode
only):
• Turn on both speakers (long press button a), select Bluetooth mode and connect one of the
devices to the signal source.
• On a speaker that is not connected to the signal source, long press button b to turn on the
TWS mode. The speakers will connect with each other.
Note. At the subsequent inclusion of both speakers, they will be connected automatically.
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose the item name "SVEN PS-150" / "SVEN PS-155" and
the “connect” command onthe source .