ENG
5
PS-710
User Manual
display shows “BLUE” inscription.
• It is necessary to select the search mode of devices with Bluetooth on a signal source (tele-
phone, notebook, smartphone, etc.). “SVEN PS-710/730/770/800/850”, massage will be displayed
onthescreen whichis to be connected to*.
• When connection is successful, there will be a short beep and the indication of the search
mode on speaker system is over**.
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose the item name “SVEN PS-710/730/770/800/850”
andthe “connect” command on the source.
Connecting to the speaker via Bluetooth using NFC
NFС works only with Android devices (version 4.1 and later).
To connect the speaker to a smartphone, the smartphone must be equipped with an NFC chip.
It must be enabled in the wireless settings.
• Turn on the speaker system Bluetooth mode — press button МODE k several times until
display shows “BLUE” inscription.
• Hold the phone close to the NFC mark i on the top panel and wait for a short beep to conrm
a successful speaker connection.
Note. You need to allow connections on the phone (depending on the phone’s operating system).
Radio mode
Attention! To improve the reception quality of the radio signal, connect the 3.5 mm mini-jack
cable (included) to the AUX input
f.
• Turn on the speaker system — press button МODE k several times until the display shows
the station frequency. Long-term pressing button o activates auto search mode. After scan-
ning completion, the rst scanned radio station will start to operate automatically. With buttons
l and p select a desired radio station.
Player mode
Attention! The le system of a micro SD carrier is FAT32. Maximum volume is 32 GB.
Fig.3. Connection diagram
PC
Mobile
device
Mini-jack to mini-jack
Power
adapter
To Next Page
Loading...
