Sven PS-770 - Connection and Operation

ENG
4
Party Speaker System
withBluetooth and FM-radio
o MIC MENU: Microphone volume/Echo level adjustment (short pressing).
p
: next track (short pressing in Player and Bluetooth mode); Navigation on the track (long
pressing in Player and Bluetooth mode); Next station (short pressing in Radio mode); Search
forastation with a higher frequency (long pressing in Radio mode).
q VOLUME +/-: volume control knob.
r TWS: Connecting an additional speaker.
s MIC PRI: Enable microphone priority mode (short pres-
sing).
t BASS/TREBLE: Bass/treble level adjustment.
u EQ: EQ mode switch button.
v REPEAT: Repeat mode selection button (in Player mode) or
RESET: reset settings (long pressing).
w
ST.BY/LED ON/OFF: On/O backlight (short pressing) or Stan-
ding by (long pressing).
Remote control
a
: switch backlight color; switch backlight mode.
b
: On/O button.
c EQ: EQ mode switch button.
d +/- : volume up/down.
e
: previous track (short pressing in Player and Bluetooth
mode); track navigation (long pressing in Player andBluetooth
modes); previous station (in Radio mode).
f TWS: Connecting an additional speaker.
g MODE: switching modes button: Bluetooth/Radio/Player/
LINE IN (short pressing); ON/OFF the service signals (long
pressing).
h 0-9: numeric pad for entering track number (in Player mode)
or number track/station (in Radio mode).
i REPEAT: Repeat mode selection button (in Player mode).
j
: Mute (short pressing); Turning on/o the backlight
(long pressing).
k BASS/TREBLE: Bass/treble level adjustment.
l
: next track (short pressing in Player and Bluetooth mode); track navigation (long pressing in
Player andBluetooth modes); next station (in Radio mode).
m MIC: Microphone volume/Echo level adjustment (short pressing); Enable microphone priority
mode (long pressing).
n RESET: reset settings (long pressing).
o
: Play/Pause button (short pressing in Player andBluetooth mode); Start/Stop auto scan
(long pressing in Radio mode); Mute (short pressing in Radio andLINE IN mode); Disconnect
from device (long pressing in Bluetooth mode).
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Speaker system battery charging
• Connect speaker system to a charger. During battery charging the indicator b is red. Indicator
b will be light green when the battery is charged.
• The battery is used in the speaker system as an integral part of the device, therefore do nottry
toextract or replace it, because this can result in the warranty cancellation or the device damage.
Fig.2.
a
b
c
d
e
d
f
g
h
i
j
k
l
o
m
n