12 User Manual
Commissioning
Assembling the Lawn Mower
Checking the Cylinder Adjustment
Take the mower out of the box. The best way is to carefully cut the box from its front face and push the mower out.
Do not ever use the handle on the mowing cartridge for lifting the mower or its transport.
Regularly check adjustment of the cylinder against the bed-knife before each mowing. When adjusting, use the 8 mm
wrench. Mower with 45 cm (18in) cutting width has 2 adjusting screws on the cylinder and 55 cm (22in) cutting width
has 3 adjusting screws.
1. Straighten the handlebars
1. If the cylinder does not
provide smooth cut mowing,
tighten up the adjusting
screws
25
clockwise.
Proceed carefully by
tightening them by approx.
10°. If required, repeat the
procedure.
2. Close the petrol supply.
3. Tilt the machine onto
the handlebars for only
necessary time period. High
possibility of oil spillage!
4. Insert a piece of paper in
front of the bed-knife
26
and
carefully turn the cylinder
with your other hand.
5. If the paper has been cut by all
the blades in whole width, the
cylinder is adjusted. A light
touch of cylinder blades with
the bedknife is normal.
2. Secure with screws 3. Adjust position and angle of
the handlebar body
Install the grass box as shown in Figure 3. The grass box is an integral part of the machine.
Adjust only with
protective gloves on and
the machine stopped.
An excessive pressure between the cylinder and the bed-
knife will result in an excessive wear of blades as well as
the driving belt. When properly adjusted, the cylinder
should turn smoothly.
25 26
To Next Page
Loading...
