MANUAL SETTING
3.Press the device key (e.g
TV1,VCR SAT1 etc.) You
want the remote to control
and release, LED flashes
once.
Brand of TV
1
A
2
AB 3006
3
AB PRODUCTION 2047
4
ACTION 3052
5
ADR 3048
6
AGASHI 3077
7
AGS 3083
8
AKAI 2189,2117
1. Look up the four-digit code
for your brand and type of
equipment in the code list .
5.Press the four-digit code
for your equipment. Each
time you press, LED flashes
and turns on.
2.Turn on the equipment you
want the remote to control,
and point the remote toward it.
4.Press and hold the [SET] key
until LED turns on.
6. Aim the remote at the device,
press a button to check if that
button works . But not [OK]
button. For example, press the
[POWER] button to see if it can
turn off the device. Check that
the other buttons of the remote
are operating the corresponding
functions of the device.
7. Press [OK] to save the
correct code if all the function
keys are working.
Notes :
1.If LED flashes four times and then turns on , it indicates the code
is not existing or effected. You d better try other codes . So please
press [SET] again, LED will flash once . Then enter a new code from
the code list.
2.If no key on your remote is pressed after 30 seconds, the programming
process will stop.
3.Aim the remote at the device, press the corresponding device and
press a button to check if that button works. For example, press the
[power] button to see if it can turn off the device. Check that the other
buttons of the remote are operating the corresponding functions of the
device. If the remote does not work, please check the code and brand
again and repeat programming again. If the remote still does not work,
please try other codes from the code list.
4.If there isn t any code working with your device , please try our Quick
Searching , Power Searching .
To Next Page
Loading...