MENU
CH
VOL
GUIDE
BACKUP
FREEZE
EXIT
+
-
Quick Searching
2.Press the device Key (e.g.
Tv1, VCR, SAT1, etc) you
want the remote to control
and release
1. Turn on the equipment you
want the remote to control,
and point the remote toward it.
3.Press and hold [SET] until
LED turns on. It stands for
entering the Quick Searching
Mode.
5.Each time you press the [UP]
or [DOWN] , a new code
number will be transmitted.
LED flashes every pressing .
Keep trying until your device
is powered off. (You can power
on the device again by hand
and test whether the function
keys are working , such as CH+,
CH-, PLAYBACK , but except for
the [OK], [UP],[DOWN] keys)
Be patient as you do this, it
may take about more than 100
tries until the correct code
number is located.
4.Quick Searching Mode:
Press and release[ MUTE],
LED will flash once, then
press [UP] or [DOWN] to
enter the quick searching.
6.Press [OK] to save the
code if all the function
keys are working .
7.If it can not work, please
repeat step 2 to 6.
Notes: If no key on your remote is pressed after 30 seconds,
the programming process will stop.
To Next Page
Loading...