MENU
CH
VOL
GUIDE
BACKUP
FREEZE
EXIT
+
-
Power Searching :
2.Press the Device Key (e.g.
TV1, VCR, SAT1, etc) you
want the remote to control
and release.
Power Searching
1.Turn on the equipment you
want the remote to control,
and point the remote toward it.
3.Press and hold the [SET] key
until LED turns on.
5.Press [OK] to save the code
when the device is powered off.
6.You can power on the device
again by hand and test whether
the function keys are working,
such as CH+,CH-, PLAYBACK.
If the function keys are not
working , repeat step 1 to step 5.
Note:
When it is searching the code automatically in step 4, you can press any
key (except for the [OK][UP][DOWN] keys)to exit the power searching
mode without any setting.
4.Press [POWER] and release,
LED goes off and then flashes
every 3 seconds. It stands for
entering the Power Searching
Mode. In searching , you can
press [UP] or [DOWN] to
change the searching
direction .
To Next Page
Loading...