Setting 5 L2TP
1. Left in the column, click “Network". Now click “WAN”.
2. Under “WAN Connection Type” select “L2TP”. This setting is for providers who use an L2TP connection.
3. Under “User Name” enter the user name you received from your provider.
4. Under “Password”, enter the corresponding passport.
5. Click “Save” to save the settings.
6. Click “Connect” to make the Internet connection. Next to this button the message “Connected” appears and your Internet IP address will
be displayed under “Internet IP Address”. It can sometimes take up to 1 minute for it to be shown. You have now completed the configuration
and are ready to surf the Internet.
If after 1 minute the router continues to show as ”Disconnected”, check your settings again and complete the following steps:
1. Switch off the router and the modem.
2. Disconnect the network cable between the router and the modem at the “WAN” port.
3. Switch on the router and wait until it is fully started up.
4. Switch on the modem and wait until it is fully started up and until all the correct lights are lit.
5. Reconnect the network cable between the modem and the router via the “WAN” port of the router.
6. Connect the router via 192.168.50.1 and check your Internet connection in the status screen by clicking “Status” left in the column. The “WAN”
section will display your Internet IP address.
To Next Page
Loading...
