Opening ports in the router (Forwarding and DMZ)
The built-in firewall in this router cannot be disabled. However, ports can be opened for programmes and games which require this.
We recommend using a fixed IP address for computers for which ports are opened. This is to ensure that these computers always use the same IP
address as registered in the router. The router may assign a different IP address to the computer so that the forwarding or DMZ command no longer
applies to that computer.
By clicking “Forwarding” left in the column the port settings can be changed.
1. Under “Service Port”, enter the port or the range of ports you want to open. For example: 3500-3600 opens all ports within that range.
2. Under “IP Address”, enter the IP address of the computer for which you want to open these ports.
3. Tick “Enable” to activate this line.
4. Click “Save” to save the settings.
You can complete 16 lines. Click “Next” to show lines 9 – 16.
To Next Page
Loading...
