Need help?Do you have a question about the Swegon CASA and is the answer not in the manual?
General| Voltage | 230V |
|---|---|
| Operating Temperature | -20°C to +40°C |
| Airflow | Up to 450 m³/h |
| Control System | Integrated |
| Mounting | Wall |
| Frequency | 50 Hz |
Emphasizes that only qualified personnel should perform installation, configuration, and commissioning.
Advises on mounting orientation, placement relative to ventilation units, and avoiding airflow obstructions.
Details requirements for clean ducts, insulated pipes, and completion of dust-generating work before commissioning.
Highlights considerations for planning, including ground source heating well freezing and necessary protection.
Covers unit placement in the outdoor air duct, horizontal mounting, condensate outlet connection, and spacing.
Details connecting heating medium pipes, venting, coarse filter installation, and ensuring no undue stress on connections.
Explains installing the SET connection unit, sensors, actuators, and connecting cables according to diagrams.
Describes setting the start temperature for external pre-heating based on outdoor temperature.
Explains setting the start temperature for external pre-cooling based on outdoor temperature.
Covers selecting temperature sensors and fine-tuning measurements via the Sensor/Control menu.
To Next Page
