Need help?Do you have a question about the Swegon TACTouch TAC6 and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Connectivity | Ethernet, USB |
| Input voltage | 24 V AC/DC |
| Protection class | IP20 |
| Display | Touch display |
| Compatibility | Swegon air handling units |
| Operating temperature | 0°C to +45°C |
| Storage temperature | -20°C to 70°C |
| Relative humidity | 10% to 90% (non-condensing) |
| Communication | Modbus |
Device features a touchscreen; describes basic navigation and symbols.
Disconnect power before installation. Do not mix cable poles.
Install EMC filter (ZCAT1518-073) on cable loop 120mm from panel.
Use dry cloth. Avoid solvents, wet cloths, sharp objects, water spray.
Illustrates TACTouch connection to TAC6 controller.
Shows TACTouch wiring for TAC5 DT/DG controller.
Illustrates TACTouch connection for TAC5 DM controller.
Configure SAT MODBUS with correct address for centralized TAC5/TAC6.
To Next Page
