EasyManua.ls Logo

SWELLPRO SPLASH DRONE - Page 37

SWELLPRO SPLASH DRONE
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
©2016 SwellPro All Rights Reserved
37
b). Check if the setting of radio controller has been changed. Turn on the radio controller and check the
main interface, check whether the scale of the sub-trim ne tuning is at normal '0' position. And switch
the SWB & SWC back and forth to check whether the ight modes are exactly corresponding to every
single ip.
c). Check the indicator inside of the receiver. Usually, The indicator is solid red and solid green during
ight operations.
3. If any abnormalities occur, Please follow the following guide to implement normal operations.
a). Reset Radio controller: Turn on the radio controller, adjust the 4 sub-trim switches around the
joysticks to change the value of ne-tuning to the '0' position.
4). Restore the radio controller to ex-factory settings if necessary, here are the steps:
a) Long press "Mode" button for 1 second to enter into the [BASIC MENU], slide the right roller switch
to select the "MODEL TYPE", short press "Push" button to access the main interface of [MODEL
TYPE];
b) Slide the roller to select "RESET: Execute", long press "Push" button for 1 second, the system pops up
an notice "Are you sure?", then short press "Push" button to conrm, it will automatically change into
remind "Please wait..."
c) The radio controller nishes the factory setting after the continuous "beep" sound and ends up with a
long "beep" sound.
3). Please refer to below video link to check out the binding procedure between Splash Drone radio
controller and its receiver.
Youtubehttps://youtu.be/uOzK_DMJNkA
4). Disconnect the battery and switch o the radio controller, try to unlock the drone while other
switches are in their defaulted position.
Notice: Normally, if the Splash drone is calibrated successfully, it's available to unlock under ATTI mode
no matter indoor or outdoor.be sure propellers are not installed or you are clear of the spinning props!
Good GPS signal is a must when unlocking the drone outdoors under the GPS mode, the value of
satellites should reach at least 9.

Other manuals for SWELLPRO SPLASH DRONE

Related product manuals