FITTED EQUIPMENT
114
3. The control panel in setting menu with
unlocked tool menu. In order to get to the
tool menu, press the symbol.
9. The tool menu - functions
When you are in the tool menu (see section 8),
you can use the tools described below. Step
between the various fields by pressing the up
or down arrow symbols. You can always leave
the tool menu with the MENU button.
Note: Functions marked with * indicate that
the symbol for the function is displayed on
the control panel even if the accessory is not
installed!
1. Arrow symbols
Step between the various tool
fields by pressing the up or
down arrow symbols. You can
always leave the tool menu with
the MENU button.
2. Clock
The clock must be set if
automatic temperature change
or automatic start is to be used.
If 12V voltage is lost, the clock
will stop and will no longer be
displayed. This is prevented
with an optional mounted
battery backup.
3. Automatic temperature
change
This function is used when
you want to programme a
timed temperature change, for
example, to have the heating
temperature raised in the
morning and lower during
the night.
ALDE HEATING OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General
