EasyManuals Logo

Swift Tourer User Manual

Swift Tourer
223 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
FITTED EQUIPMENT
105
Fault
Cause Rectification
After switching on (winter and
summer operation) none of
the LEDs are lit.
- No operating voltage
- Device fuse or vehicle
fuse defective
- Check 12 V battery
voltages, change if
necessary.
- Check all electrical plug
connections
- Check the unit or vehicle
fuse and replace if
necessary (see fuses)
The green LED comes on
when the unit is switched
on but the heater does not
operate.
- The temperature setting on
the control panel is lower
than the room temperature
- Select higher room
temperature at the control
panel
After the heater is switched
on, the green LED is lit and
the red LED blinks.
- Electronics are defective - Please contact the Truma
Service Centre
Approximately 30 seconds
after the heater is switched
on, the red LED is lit.
- Gas cylinder gas shut off
valve at the manifold is
closed
- Combustion air infeed or
exhaust outlet is sealed
- Check gas supply and
open valves
- Inspect opening for
contamination (slush, ice,
leaves, etc.) and remove
contamination if necessary
After operating for a longer
period of time, the heater
switches to failure.
- Summer operation with
empty water tank
- Hot air outlets blocked
- Recirculated air intake
blocked
- Gas pressure regulator
iced up
- Butane content in the gas
cylinder too high
- Switch device off and allow
to cool. Fill boiler with water
- Check individual outlet
aperture
- Remove blockage from
recirculated air intake
- Use regular heating (EisEx)
- Use propane (at
temperatures below 10˚C
in particular, butane is
unsuitable for healing
purposes
Green and red LEDs blink
after heater is switched off
- Unit was switched off during
failure. After running is
active in order to reduce the
unit’s temperature
- After running will switch off
after a few minutes. Only at
that time will a failure reset
be possible (switch off and
then back on)
Green LED blinks after heater
is switched off
- After running is active in
order to reduce the unit’s
temperature
- No failure. After running
will switch off after
approximately 5 minutes
TRUMA COMBI BOILER FAULT FINDING

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Swift Tourer and is the answer not in the manual?

Swift Tourer Specifications

General IconGeneral
BrandSwift
ModelTourer
CategoryMotorhomes
LanguageEnglish

Related product manuals