37
FIRE ALARM
2. Remove the existing battery and replace
with a new battery. From the list on the
previous page, making sure that the
positive and negative connections are
in the correct position. If unsure see the
alarm user manual.
3. Replace the alarm on its mounting plate,
lining up the large central vent on the front
of the alarm, with the ‘X’ that is moulded
into the plastic on the mounting plate
(if unsure see page 13 of the alarm user
manual). Ensure the unit is securely fitted.
4. Test your alarm as explained in the next
section ‘Alarm Test’.
ALARM TEST
1. Press the test button in the centre and
release.
2. The unit will emit a loud (85dB at 3 meters)
alarm for around 5 seconds and stop
automatically.
3. The red LED on your alarm will flash
rapidly during the audible signal.
To Next Page
Loading...
Need help?
General
