FITTED EQUIPMENT
169
Double bed assembly (Fig. C)
1. Grip front of slatted bed and walk
backwards until bed is fully extended.
2. Arrange seat cushions as appropriate.
Fig. C
Lift-up bunks
1. Release catches, one at a time.
2. Release press studs on the bed board.
3. Grasp the bunk as shown and pull
carefully in direction of arrows.
4. The bunk is designed to automatically
move into the correct position.
5. Where a bed board is fitted, unfold and
make sure it is secured by press studs
when lifted into position. (The bed board is
required to protect both the occupant and
the window from damage during use of
the bunk.)
6. Locate safety boards.
7. Arrange seat cushions as appropriate.
Bunks are designed to carry a child to a
maximum of 70kg (11 stone)
WARNING: Use upper bunks for sleeping
only, with the provided protection against fall
out in position
WARNING: Care shall be taken against the
risk of fall out when the upper bunks are in
use by children especially under 6 years of
age, these bunks are not suitable for use by
infants without supervision.
To Next Page
Loading...
Need help?
General
