swimmax 07iPS - Setting Controller Parameters; Diagnosing Error Codes; Setting Time and Timers

- 20 -
7.2.7 Parameter setting
Select and press to enter, press and to set P0-P16 value.
Note: Long press for 15s to set P14,.
P8,P9,P10,P11,P18 parameter is only for factory setting.
7.2.8 Error code
Select and press to check the error code. If the HP is normal, button is invalid.
7.2.9 Time setting/Timer setting
Select and press to enter, press again to Timer on/Timer off setting.
Code
Name
Scope
Default
Remark
P0
Mandatory defrosting
0-1
0
0: Default normal operation
1: mandatory defrosting.
P3
Water pump
0-1
0
1:Always running;
0:Depends on the running of compressor
P7
Water temp. calibration
-9～9
0
Default setting: 0
P14
Reset factory setting
0-1
0
P16
CODE
Related with the model,Not adjustable
P18
Product Range
Only for factory setting