SWIMN S1 - Powering On and Off; Starting Up the Scooter

To Next Page

To Previous Page

Powering On/O󽗈

1. Press and hold the power button for one second to power on.

2. Press and hold the power button for three seconds to power o󽗈.

Note: The product will power o󽗈 automatically when it is not in use for more than 30 minutes.

In any emergencies while using SWIMN S1, press the power button for three seconds to shut down the product.

Starting Up

Press both start buttons at the same time to start.

Note: After starting up successfully, you only need to press one button to keep running.

The product will switch to Protection Mode with lower motor speed after operating in the air for about 󽗉ve seconds.