Swisher PREDATOR - Page 10

ENGINE & PULLEY ASSEMBLY
Item # Description Part #
1 5/16-18 X 1 1/4 Serr. Flange Bolt NB253
2 5/16-18 X 3/4 Serr. Flange Bolt NB596
3 Bracket - ON/OFF Switch, Txt Blk 19201*
4 Switch - Toggle 19192
5 5/16-18 Serr. Flange Nut NB170
6 Belt Retention Weldment 10767
7 Engine Pulley Spacer 1.75" Long BB105S
8 1/4 X 1/2 Key Stock 4258
9 Engine Pulley- 2.5" 2411
10 Engine Pulley- 4.25"OD,1 1/4 ID BB105
11 Washer Belleville 699
12 Bolt - Serr Flange, 5/16-18 X 1 3/4 Gr5 NB515
13 3/8-16 2 Way Locking Nut NB280
14 Idler Pulley OD-2.16", ID-3/8" B27
15 Transmission Belt-35" 690
16 1 X 1 1/2 10GA Washer NB614HT
17 1/4 X 1 Key Stock 9031
18 Washer, Front Wheel TR150W
19 7/16-20 X 1 1/2 HCF GR5 ZP Nyloc NB637
20 Engine B&S Recoil St W/Gas Tank N/A
21 Nut - Nyloc 5/16-18 ZY NB181
22 Valve - Oil Drain 16000
23 Guard - Wire 19478*
24 1/4-20 Serr. Flange Nut NB524
25 Motor Plate 19213*
26 3/8 SAE Washer NB272
27 3/8-16 X 1 1/2 HCCG NB107
28 Spring T2SM
29 1/4-20 X 3/4 GR5 ZP Bolt NB250
30 Idler Arm 10671*
31 Idler Bushing 6037
32 3/8-16 X 1 GR5 ZP Bolt NB604
Not Shown Transmission Cable 19209
10
Important:
Spring
must be hooked in
Idler Arm as shown.
Install Transmission Cable
(Not Shown) in Idler Arm
before installing Idler Arm
to Motor Plate.
When ordering replacement parts
*USE PAINT CODE: TK=BLACK