Welding and cutting is dangerous to the operator, people in or near the working area, and the
surrounding environment. Therefore, the performance of welding and cutting must only be done
under the strict and comprehensive observation of all relevant safety regulations. Please read and
understand this instruction manual carefully before installation and operation.
•Switching function modes during welding could potentially damage the equipment.
•Disconnect the electrode-holder cable from the equipment before welding.
•A safety switch is necessary to prevent the equipment from electric-leakage.
•Use only high quality welding tools and equipment with this Inverter.
•Operators should be suitably trained to use this equipment.
Warning
Electric Shock
•Connect the earth cable according to standard regulation.
•Avoid any contact with live components of the welding circuit, electrodes
and wires with bare hands. The operator should wear suitable welding
gloves while using this machine.
•The operator should keep the work piece insulated from himself/
herself.
Smoke and Gas generated while welding or cutting
•Avoid breathing in smoke and gas from welding or cutting.
•Make sure the are you are working in a well ventilated area.
Arc light-emission
•Always wear a welding helmet and appropriate work clothes while
welding.
•Measures should also be taken to protect people in or near the area
you are working.
Fire hazard
•Sparks from welding may cause re. Remove any ammable items from
the immediate area before welding.
•Have a re extinguisher nearby.
Noise
•Surface noise is generated while welding and cutting. Use suitable
hearing protection.
Machine Fault
•Consult this instruction manual in the case of a fault.
•Contact your local dealer or supplier for further advice.
To Next Page
Loading...
General