SPECIFICATIONSSPECIFICATIONS
NOTE: All measurements were taken with a line voltage of 120VAC.
ELECTRONICS
Maximum Power at 1KHz Under Clipping
120 Watts RMS @ 8 ohms (head only w/ 8 ohm speaker enclosure)
160 Watts RMS @ 4 ohms (internal speaker complement)
180 Watts RMS @ 2.6 ohms
200 Watts RMS @ 2 ohms
Power Amp Distortion (1KHz)
0.02% THD, 100 Watts RMS @ 8 ohms
0.03% THD, 100 Watts RMS @ 4 ohms
Intermodulation Distortion @ 8 ohms, 100 Watts RMS, 60/7KHz, 4:1
0.05%
Frequency Response (power amp)
-3db at 10 Hz and 22KHz
System Distortion (Gain and Master Volume full, enhancer and tone controls set flat, 1KHz)
0.5% THD
Sensitivity (for full output @ 8 ohms, 1 KHz)
Passive/Active Input Jack = 10 millivolts
Active Input Jack = 50 millivolts
Input Impedance
Passive/Active Input Jack = 800K ohms
Active Input Jack = 60K ohms
Effects Return Jack = 27K ohms
Output Impedance
Effects Send Jack = 100 ohms
Line Out Jack = 100 ohms
Tuner Out Jack = 100 ohms
Headphone Jack = 100 ohms
Signal to Noise Ratio, Unweighted (7 millivolts typical, mostly hum)
-72db
Equivalent Input Noise
2.5 micro-volts
2 • BABY BLUE II OWNER’S MANUAL
To Next Page
Loading...
