SY OMEGA 3 - RJ-45 Wiring; Specifications; General

sy.uk 10 V2.02
Note:
MFT31-H is designed to power the remote transmitters (iPoC capable) using the provided
48V PSU. It can also power non iPoC transmitters by using appropriate 24V PSU.
The MFT31-H can’t be powered by the remote transmitters.
RJ-45 Wiring
Both connectors must be wired identically.
HDBaseT signals will NOT pass through any Ethernet device. The HDBaseT ports on this device
must be connected directly to the HDBaseT port of the remote Transmitters.
Please do make sure that the Cat6 cable uses 4 pairs of 23AWG solid copper wires. Do not use
inferior copper clad cables as these exhibit much higher resistances.
Specifications
General
HDMI Version
Input: HDMI 2.0 - HDR (10, 12) and HBR supported
Max Bandwidth
HDMI Input: 18 Gbps (4K60 4:4:4)
HDBT input: 10.2 Gbps (4K60 4:2:0, 4K30 4:4:4)
HDMI output: 18 Gbps (4K60 4:4:4)
HDCP Compliance
Input HDCP: 1.4 and 2.2
Output HDCP: Fully controlled – Pass, 1.4, 2.2, Cascade mode
RS232 (Control Commands – Tx, Rx)
57600 baud, 8 data bits, 1 stop bit, no parity
RS232 (Pass-Through – Tx, Rx)
Any baud rate to maximum of 115200.