SY OMEGA 3 - Test Pattern; Setting Auto or Manual Switching Mode; Input Selection

V2.02 7 sy.uk
Command
Details
SET OMEGA NO-SIGNAL-HANDLE TEST-PATTERN
Output Test Pattern when no input signal
SET OMEGA NO-SIGNAL-HANDLE NO-TIMING
No output when no signal – VKA off
(default)
GET OMEGA NO-SIGNAL-HANDLE
Get the current No Signal Handling mode
Test Pattern
The test pattern mode of the MFS31-H is useful for testing the HDMI output to the display device.
Two options are available and both must be specified in the command:
 Pattern
 Resolution
Command
Details
SET OMEGA TEST-PATTERN x y
x is Pattern - select one of following options:
BLACK, RED, GREEN, BLUE, WHITE,
RED_RAMP, GREEN_RAMP, BLUE_RAMP,
PRBS, RAMP, STRIPE, CHECKER-BOARD (default)
y is Resolution - select one of following options:
4K60, 4K30, 4K25, 4K24, 1080P60, 720P60
GET OMEGA TEST-PATTERN
Get the current Test Pattern mode
Setting Auto or Manual Switching Mode
The switching mode command sets the following options:
 Manual: Inputs can be selected by briefly pressing the “Select” button.
 Auto: Auto selects when new active input detected. When currently selected input
video is lost, it will select the next available. Also, only active inputs can be selected
using the “Select” button.
Command
Details
SET OMEGA SWITCH-MODE MANUAL
Manual switching mode selected (default)
SET OMEGA SWITCH-MODE AUTO
Auto switching mode selected
GET OMEGA SWITCH-MODE
Get the current switch mode
Input Selection
The MFS31-H inputs can be selected with one of the following three options:
 HDMI-INPUT
 HDBT1-INPUT
 HDBT2-INPUT
Command
Details
SET OMEGA MANUAL-SWITCH-MODE w
w is input, select one of following options:
HDMI, HDBT1, HDBT2
GET OMEGA MANUAL-SWITCH-MODE
Get the current Manual switch mode