SY OMEGA 3 - CEC Commands; Set Safety Temperature

V2.02 9 sy.uk
CEC Commands
The following group of RS232 commands are only possible with display devices that support CEC
commands. Use the Error! Reference source not found. Connection Status RS232 command to
determine the CEC capability when the display device is fully powered.
CEC commands are most useful when it is not practical to use RS232 connection to the display.
Set Safety Temperature
The following command sets the Power Off, Warning, and Re-Power temperatures. There is also
a command to enable or disable this feature:
Command Send
Details
SET OMEGA SAFE-TEMP-ONOFF ON
Enable MFS31-H safety temperature handling
SET OMEGA SAFE-TEMP-ONOFF OFF
Disable MFS31-H safety temperature handling
GET OMEGA SAFE-TEMP-ONOFF
Get current OMEGA SAFE-TEMP-ONOFF state
SET OMEGA SAFE-TEMP-VALUE x y z
Set shut down temperature x
Set warning temperature y
Set re-power temperature z
Default: x=75, y=70, z=65 (℃)
x>y>z>55
GET OMEGA SAFE-TEMP-VALUE
Get the current OMEGA safety temperature values
CEC Commands
Details
Display On
SET OMEGA DISPLAY-ON
Set Display to the ON state
Display Off
SET OMEGA DISPLAY-OFF
Set Display into the standby state
Volume Increase
SET OMEGA CEC-VOLDEC
Increase sound volume
Volume Decrease
SET OMEGA CEC-VOLDEC
Decrease sound volume
Volume Mute
SET OMEGA CEC-MUTE
Mute/Unmute sound volume (Toggle)
Display Connection Status
GET OMEGA READ-DISPLAY
Get the current Connected/Disconnected info
Display Power Status
GET OMEGA DISPLAY-POWER
Get the current display device power on/off info