DIGIEYE COMPACT Informazioni di base
EN-UM-DGI.CO2.A
Rev. 1.4
Page 6
Refer to the below chart to configure the connections, depending on the
number of monitors to be connected to the DigiEye:
2 monitors
(2)
(HDMI+VGA)
2 monitor
(2)
(HDMI+CVBS)
(1)
It’s possible to force Aux in the system reinitialization program
(2)
The monitors must be connected and switched on BEFORE powering up
Digieye. If Digieye restarts and does not find the connected monitor (eg.
The monitor is turned off) this will not be detected by Digieye,
consequently disabling the Main / Aux output. You will need to restart
the Digieye system to detect the monitor.
DigiEye automatically detects the monitors connected to the system at boot and
sets the MAIN/AUX video interfaces resolution to optimal values.
We recommend to use monitors with the following technical characteristics:
1024 x 768
1280 x 1024
1600 x 1200
1440 x 900
1920 x 1080 (Full-HD o 1080p) (*)
(*) The new DigiEye user interface (dark gray) is enabled only when a Full-HD
primary (MAIN)monitor is being used (resolution 1920x1080).
If no monitor is connected to the system at boot, it will activate the MAIN or AUX
interface anyway (depending on the configuration) that will be displayed once a
monitor will be connected on one of video interfaces.
When you change a monitor or a video port, we suggest to reboot the system
(shutdown/restart).
2. Connection of USB devices
Connect the USB devices using the below chart:
USB
(1 on the front and 2
on the rear, white)
CONV.USB-485 (opt.) – COM3
USB 3.0
(2 on the rear, blue)
CONV.USB-485 (opt.) – COM4
3. LAN/WAN Network Connection
To Next Page
Loading...