Sylvac S Dial WORK ANALOG NANO Smart - List of Main Commands; Selection and Configuration Commands; Maintenance Function Commands

22
E
16. List of the main commands
Selection and conguration Interrogation
CHA+ / CHA- Change measurement direction CHA? Measurement sense?
FCT0 ...9...A...F Assign «favourite» function FCT? «favourite» function active?
MM / IN Change measurement unit UNI? Measurement unit active?
KEY0 / KEY1 Lock / unlock keypad KEY? Keypad locked?
MUL [+/-]xx.xxxx Modication of the multiplier MUL? Multiplier value
PRE [+/-]xxx.xxx Modify preset value PRE? Preset value?
STO1 / STO0 Activate / de-activate HOLD STO? Status of HOLD function?
TOL1 / TOL0 Activate / de-activate tolerances TOL? Current tolerance limit values?
ECO1 / ECO 0 Activate / de-activate economic mode ECO? Current economic mode
INTE1 / INTE0 2 points measurement mode INTE ? 2 points mode ?
LCAL dd.mm.yy Modify last calibration date LCAL? Date of last calibration?
NCAL dd.mm.yy Modify next calibration date NCAL? Date of next calibration?
NUM x...x (up to 20 chars) Modify the instrument number NUM? Instrument number?
TOL +/-xxx.xxx +/-yyy.yyy Inputting nominal and current tolerance limits ? Current value (mode Tol, value followed by <=>)
+/-zzz.zzz
MIN /MAX /DEL /NOR Selecting MIN, MAX, Delta, Normal mode MOD? Active mode (MIN, MAX, Delta or Normal)?
CLE Re-initialisation of MIN, MAX or Delta SET? Main instrument parameters?
UNI1 / UNI0 Activate / de-activate change of units ID? Instrument identication code?
OUT1 /OUT0 Activate / de-activate contin. data transmission
PRE ON / PRE OFF Activate / de-activate Preset function Maintenance functions
PRE Recall Preset BAT? Battery status (BAT1 = OK, BAT0 = low battery)
SET Zero reset OFF Switch-off (wake up using a button or RS)
RES1 / RES2 / RES3 Change of resolution RST Re-initialisation of the instrument
AOFF Activates/deactivates the automatic switch-off SBY Put instrument in stand-by (SIS)
CFGBAR NOR MAX Keep Bargraph on Max value VER? Version No. and date of rmware
SBY xx xx number of minutes before stand-by CFGBAR? Bargraph conguration
Bluetooth
®
BT0/BT1 Activate/de-activate Bluetooth
®
module MAC? Bluetooth
®
MAC address?
BTRST Reset pairing information