Sylvac S Dial WORK NANO Smart - Favourite Key Configuration and Use

SET
MODE
17
E
10. Favourite key
The «favourite» key gives direct access to a predened function, and can be congured according to the needs of the
user. In order to assign a function to the «favourite» key, give a prolonged press on , and then select the required
function :
Validation of selection: By a prolonged press on or a short press on or
Note : a function can also be assigned via RS232 using the command <FCT + Function No.>
example : Change of Unit = <FCT9>, reverse the measurement direction = <FCTB>
11
Nul
no.F
9
rES
10
dir
12
13
bt
8
to
L
6
ModE
7
IntE
5
PrE
4
3 SEt
2 CLr
1 HoLd
0 dAtA
Unit
Data
transmission
(defaut)
Hold display
Re-initialise
Min-Max-Delta
Zero reset
Preset (min-
max-mode)
Measurement
direction,
positive-negative
Multiplier
No function
Recall Preset
Nor-Min-
Max-Delta
2 points
Mode ON-
OFF
Tol ON-Tol
OFF
Bluetooth
®
ON-OFF
(depends on
model)
mm - IN
0.01 - 0.001 or
0.001 - 0.0001