17
E
10. Personalising the instrument
Access to the functions of your instrument can be personalised, for more information see manufacturer’s website (re-
quires you to connect your instrument via Proximity or Power RS / USB cable, or
Bluetooth
®
).
Possibilities :
- Enable or disable the required functions.
- Modify access to the advanced functions (direct access).
11. Connecting the instrument
The instrument can be connected to a peripheral via a Proximity (RS or USB), Power (RS or USB) cable or
Bluetooth
®
.
See page 2 for connecting the Power cable.
Measured values can be transmitted and the instrument driven using predefined commands (see chap. 12 for a list of
the main commands).
Note :
- In Tolerance mode, the tolerance limit lights remain lit only for a few seconds while the measurement stabilises.
On the other hand, they will remain lit continuously if the instrument is connected to, and powered by, the Power RS
(USB) cable.
To Next Page
Loading...
