RECORDING PHONO
During PHONO playback, press RECORD button to record the PHONO audio from start
current track in MP3 format.
Press RECORD button again to stop recording.
The stored file name after recording will be “ REC1.MP3 “ in file “REC”.
Setting up (AUX IN) connection
AUX-IN jack will allow you to connect external music player or external sound source to the
main unit.
1. Plug into a 3.5mm audio cable (not included) into your external music player and
connect the other end (3.5mm jack) into the AUX IN jack on the front of the unit.
2. Make sure your external music player is turned on.
3. Press and toggle the SOURCE button to switch to AUX mode on the unit.
4. Start music playback on your external music player.
5. Adjust VOLUME control to control the sound level of music playback from the speakers
on the unit.
1. You can run the audio from the unit into your home stereo, television or other stereo
source by using the AUX output.
2. To make this connection, you need a standard RCA cable (not include). Plug the red
and white connectors on one end of the cable into the red and white AUX OUT jack on
the rear of the unit. The other end of the cable will plug into the AUX INPUT jacks of
your selected component.
3. Operate the unit as usual, you can hear the sound exported from the unit.
NOTE: You can still listen to your unit when using the Audio Output feature.
AUX IN Operation
AUX OUT Operation
9
To Next Page
Loading...
