WARNING! THIS PRODUCT USES A CLASS 1 LASER. AVOID ANY DIRECT
EXPOSURE TO THE LASER BEAM. USE OF CONTROLS, ADJUSTMENTS OR
PROCEDURES NOT LISTED IN THIS GUIDE MAY RESULT IN HAZARDOUS
EXPOSURE.
Handing Compact Discs
To remove a CD from its storage case, press down on the center of case
and lift the disc out.
Hold the disc by the edges. Avoid touching the recorded side of the disc.
Compatible Compact Discs
Only compact MP3 format discs or music discs identified with
marking shown right can be used with your CD Player.
Loading CDs / MP3 Disc
1. Press and toggle the SOURCE button to switch to CD mode.
2. Press the OPEN/CLOSE button on the front of the unit to open the CD door.
3. Hold the CDs / MP3 disc by its edge with CD graphical side facing up and put it onto the
CD compartment after the CD door is opened. Make sure that the disc label is facing
up.
4. Press the OPEN/CLOSE button again to close the CD door and make sure the
VOLUME control is not in minimum position.
CDs / MP3 Disc playback
After loading the disc, the disc will begin spinning and the total number of the tracks on the
disc will be shown on the display.
USB Device Playback (MP3 file only)
1. Press and toggle the SOURCE button to switch to USB mode.
2. Insert the USB device into the USB port. The LCD display show “----“ a few second,
the total music files number show on display.
3. Make sure the VOLUME control is not in minimum position.
4. When removing USB
device that press the
M-
/ button to stop playing first.
Play / Pause Control
Press the M+ / button to play the CDs / MP3 Disc / USB. To pause playback
temporarily by pressing again the M+ / button. Music playback will be paused and the
current elapsed track time will be shown and blanking on the display. Press the M+ /
button again to resume playback.
Remark:
If there is no disc in the unit, “NO” or “ERR” will be indicated on the display.
If the CD cannot be read, “NO or ERR” will be indicated on the dis
To Next Page
Loading...
