§ TIRE INSPECTION §
Ÿ Tires should be checked and inflated with the engine shut off.
Ÿ If a tire’s ground contacting curve is abnormal, check it with an air pressure gauge and inflate it to
the specified pressure.
Ÿ Tires pressure must be checked with an air pressure gauge when cold.
Ÿ Visual check tires for frontal and lateral side walls for
crack or damage.
Ÿ Visual check tires for any nails or small stones
wedged in the tread.
Ÿ Check the “tread wear indicator” condition to see if
tread groove depth is insufficient.
Ÿ A tire with a wear bar showing is worn out and should
be replaced immediately.
§ STEERING HANDLE FRONT SHOCK ABSORBERS INSPECTION §
Ÿ Perform this check with engine shut off and ignition switch key
removed.
Ÿ Visual check front shock absorbers for damage.
Ÿ Operate steering handle up and down, and check front shock
absorbers for noises due to bends.
Ÿ Check the bolts and nuts of front shock absorbers with wrenches
for tightness.
Ÿ Shake steering handle up & down, left & right, and front & rear to
check if it is loosen, has too much resistance and pulls to one
side.
Ÿ Check steering handle if it is being pulled too tight by the brake
cables.
Ÿ Take your scooter to SYM Authorized Dealer or Franchised
Dealer for a check or adjustment if any abnormal conditions are
found.
PLEASE REFER TO SPECIFICATIONS FOR STANDARD TIRE PRESSURE
CAUTION:
Ÿ Abnormal tire pressure, wear, or crack is the most important cause that results in the loss control
of the steering handle and a punctured tire(s).
To Next Page
Loading...
Need help?
General
