10. Inspection and maintenance before riding
【Oil Filter Cleaning】
Open the filter nut assembly of the element, and
remove the element. Remove the foreign materials
from the element by using a gasoline or air spraying
gun.
WARNING:
Oil level will not be correct when checking the oil level with the scooter parked on an unleveled
ground or immediately after the engine stopped.
Engine and exhaust pipe are hot right after engine stopped. Pay special attention not to get burned
when checking or replacing engine oil.
CAUTION：
If the oil pressure warning light activated for more than 10 seconds after engine started, please
shut the engine as soonest as possible.
It is normal that this warning light to be activated for 6~8 seconds after engine started. If this light
keeps ON more than 10 seconds or even longer, the engine oil pressure may be too low for
sufficient lubrication. An immediate lubrication check is highly advice.
Please kindly check the engine oil level by dipstick to ensure there is sufficient oil inside the
engine, if the oil level is correct yet the warning light does not disappear, please contact your
SYM dealer.
OIL PAPER FILTER CHANGE
Please check or replace according to the maintenance
kilometer.
WARING:
Exchange the oil paper filter and O-ring as well.
To Next Page
Loading...
