FUEL INSPECTION
Turn main switch key to "ON" position, and check fuel gauge's needle range to make sure there is enough
amount of fuel in the fuel tank.
This scooter’s engine is designed for using the unleaded fuel of Octane 90 or above.
Firmly secure the main stand on the ground, shut off the engine and keep flames away from the scooter
when refueling.
Do not fill above fuel upper limit level when refueling.
Make sure the fuel tank cap had been tighten properly.
TRANSMISSION OIL INSPECTION AND CHANGE
INSPECTION:
Use the main stand to support the scooter on a level ground, after
the engine stops, wait for 3~5 minutes. Remove the transmission oil
infusion bolt, put a measuring glass under the drain bolt, and
remove the drain bolt. Let the oil flows into measuring glass and
check for decreased or not.
at disassembly: 350 cc. / at change: 330 cc.
OIL REPLACEMENT:
Stop the engine and use the main stand to support your scooter on
a level ground. Remove the infusion bolt and drain bolt, drain out
the oil.
Install the drain bolt and tighten it. Fill new transmission oil (330
cc.), and install the infusion bolt and tighten it. (make sure that bolts
are tightened and check that there’s no leakage.)
※ Recommend Oil:
Genuine SYM HYPOID GEAR OIL (SAE 85W-140).
Use SAE85-90 when outside temperature is below 0℃.
To Next Page
Loading...
