INTRODUCTION TO QUADCOPTER FUNCTIONS
Low-voltage protection:
When the quadcopter battery is not enough, the rotors will be stopped power
supply.As the quadcopter control systemwill protected battery automatically.
Over-current protection:
When the quadcopter's rotating blade is collided or jammed, the control system
will stop supplying power for the rotors automatically, Then please re-match the
signal for flying.
Restart function:
In case of flight disorder or sideward flight, restore factory default settings by the
following methods:
O.Press the power switch to turn on
the transmitter.
@.Press the power switch to turn on the quadcopter.
($).When the quadcopter indicator quickly flashing
to slowly flashing,please push the throttle lever to
the highest position,and then pull it back to the
lowest position. Then the quadcopter indicator
changed from slowly flashing to normal lights up.
@.Place the quadcopter on a horizontal postion,
then push transmitter both left and right lever to
lowest right conner for about 2-3 second
indicator on the quadcopter changed from normal
lights up to quickly flashing ;After 2-3 second ,the
indicator changed to normal lights,it means the
quadcopter restarted [reset successfully.
3D EVERSION AND THROWING FLIGHT INSTRUCTIONS
When you are familiar with the basic
operation, you can do some awesome
& exciting tricks and stunts! First of all,
fly the aircraft to a height of more than
3 meters, press the 3D Eversion switch
on the rear right side of the transmitter,
and push the right rudder(in any direction)
together to make 360 degree flip.
Ips:3D eversion goes better when battery
power is enough.
-8-
3m
To Next Page
Loading...
