SYMA S36 - Battery Installation and Charging; Get to Know Your Transmitter

-2-
-
+
-
+
-
+
-
+
BATTERY INSTALLATION AND CHARGING
Unscrew and remove battery cover
from R/C unit, insert 4 ‘AA’
batteries, noting polarity indicators.
Replace battery cover.
Charging Helicopter
A. Remote control
charging
B. Computer charging
Battery Installation
Battery cover
4×1.5V batteries
ON/OFF Switch
Charge port
Plug wire in helicopter
Charging it for 60-70 minutes and you can fly about 5-6 minutes!
WHEN CHARGING BE SURE TO TURN THE WITCH
ON HELICOPTER TO “OFF”
GET TO KNOW YOUR TRANSMITTER
ON/OFF Switch
Power and indicator
High/Low
speed switch
Left control lever
UP / Down
Right control lever
Forward / backward
Turn left / Turn right
Turn left / Turn right
trimmer
USB Charge port
(A) Charging helicopter with Remote Controller: plug provided USB cord into
R/C and into helicopter. Turn on R/C, the light on the USB plug will light
up until the helicopter is fully charged – light will turn off when fully charged.
A full charge takes approximately 70 minutes.
(B) Charging helicopter with computer: plug provided USB cord into computer
and into helicopter. Turn on R/C, the light on the USB plug will light up until
the helicopter is fully charged –light will turn off when fully charged. A full
charge takes approximately 60 minutes.