SYMA X5SW EXPLORERS - Remote Control Keypad and LCD Manual; Component Installation; Landing Skids and Blade Guards Installation; Phone Attaching Clamp Installation

:,""-'*#T
l,
!-'
..
!*,
Figure 1
Figure
2 Figure
3
1.
2.
Insert foot stands into interface of lower main body as shown in
Figure
(1).
lnstall the blade
protecting
frame to every corner than lock screws Figure
(2-3\.
t'**
-
ii'
t-*
.-+
lnstallation
of
phone
attaching clamp
Figure 1
Figure 2 Figure 3
1 . Insert
phone
attaching clamp by aiming
at antenra on remote control.
(
t
)
2. Press spring of attaching
clamp forcibly to resize.
(z)
3.
Hold
phone
attaching clamp
and
pull
out
forcibly
to disassemble
phone
attaching clamp.
(:)
I
tr
t
,,
\,
,
,.
\
\*
"\
I
1.
,,,
I
{
0l.Sideward Fine-tuning :Power-on
start in the
centering.(Be
turn LefURight
Finetuning in Mode2)
02. Foruvard/Backward fine-tuning
: Power-on
start
in
the middle.
03.lurn LefVRight fine-tuning:Power-on
start
in
centering.(Be
Sidewoard
Fly
Fine-tuning
in Mode2)
04.Fonvard
shows:Power-on start in the
lowest level.(At the center
spuare)
05.Backward
shows:Power-on
start
in the lowest level.(At
the
center spuare)
06.Right sideward
fly shows:Power-on
start
in
the lowest level.(At the
center
spuare)
07.Left sideward fly shows:Power-on
start
in
the lowest level.(At
the center
spuare)
08.Turn left: Pull left function lever
to left, it will
be
higher,
than
quadcopter
,
lurn left faster.
09.Turn right: Pull left function
lever to right, it will
be higher, than
quadcopter
turn
right faster.
10.High/Low
speed: Press
button
"A"
for
seconds to switch
between
high
speed
mode
or low
speed
mode.
"H"
means high
speed and
"L"
means
low
speed.
'l1.Power
shows:According to the
battery's
energy
for the controller.
l2.Default mode
when
power-on.When
change to MODE 2,
please
keep
pressing
button "8" to right than return
on the
power
of transmitter, the
MODE on LCD displayer
will be changed.
Same steps to change to
MODE 1
again.
1
3.Signal shows:Normally to full frame.
-3-
lnstall software
ForAndroid
phone, please
download from www.symatoys.com or scan two-
dimension code to install SYMA
FPV software.
For iphone lOS,
please
download from APP STORE to
install
SYMA FPV
software or scan two-dimension code to
install
SYMA
FPV software.
4-