protection has been enabled.
RAPID CYCLING (Load Side / Downstream)
Load side rapid cycling of the pump will immediately result in a manual lock-out. The pump will not
restart automatically. To reset the PumpSaver
®
Plus, remove and re-apply power.
Note: P
rotection against rapid cycling of a control device installed after the PumpSaver
®
Plus is
always enabled. Disabling line side detection will not disable load side detection.
USING AN INFORMER
PumpSaver
®
Plus products are equipped with an infrared LED that will communicate to a SymCom
Informer—a handheld, battery-operated, diagnostic tool. The Informer—when directed at the
PumpSaver
®
Plus—will display real-time voltage, current and power; dry-well and overcurrent trip
points; calibration voltage; last 20 faults; voltage, current and power at the last fault; highest/lowest
voltage and current since calibration; the model number; and the CT size if applicable. The Informer
can be used on any single-phase PumpSaver
®
Plus equipped with an infrared LED transmitter.
Contact SymCom for more information at 800-894-0412 or visit our website.
To Next Page
Loading...
Need help?
General
