Other Controls Switches and Displays
G
AIN(DB)
Increases the output level of the 425. Use this control to
restore signal level lost by compression or limiting.
Note: the unity gain position of the control (0 dB) is referenced
to the balanced output connector. If you are using the
unbalanced output, unity gain occurs when the the
GAIN
control is set to +6 dB.
LED Display Indicates the output level of the 425.
IN/BYPASS
This switch bypasses the 425. This is NOT a hard-wire bypass;
the 425 will not pass signal unless the unit is powered and
turned on.
DUAL / STEREO
This switch selects dual-mono or stereo-coupled mode. In
dual-mono mode, each channel of the 425 operates
independently.
In stereo-coupled mode, the channel 1 controls determine the
settings for both channel 1 and channel 2. Channel 1's
sidechain receives a mono mix of the channel 1 and channel 2
signals. The LED displays for channel 2 blank (except for the
output display) to remind you that the channels are stereo-
coupled.
The remaining controls and switches on the front panel
duplicate those previously described for channel 1.
Rev 2.0, 10/29/93
4-2
To Next Page
Loading...
