Proper Fuse
The fuse is mounted internally and is not considered
user serviceable. The fuseholder accepts American sized
fuses (1/4 in dia.) or European sized fuses (5mm dia).
For 117 VAC operation, the correct value is 1/4A,
250VAC, fast blowing (bussman type AGC)
For 230 VAC operation, the correct value is 1/8A,
250VAC, slow blowing (Bussman type MDL or GDC.
Operating Location
Do not operate this equipment under any of the
following conditions: explosive atmospheres, in wet
locations, in inclement weather, improper or unknown
AC mains voltage, or if improperly fused.
Stay Out of the Box
To avoid personal injury (or worse), do not remove the
product covers or panels. Do not operate the product
without the covers and panels properly installed.
User-serviceable parts
There are no user serviceable parts inside the 425. In
case of failure, refer all servicing to the factory.
Rev 2.0, 10/29/93
1-4
To Next Page
Loading...
